2.10 Starting the Advanced Hybrid System

2.10.1 Starting the Advanced Hybrid System

This section explains the procedure for starting the PBX for the first time, with default values, or when you wish to re-initialise the PBX.
1. Make sure that all outside (CO) lines you use are connected to the PBX.
2. Set the Power Switch to the "OFF" position.
3. Connect the AC cord to the PBX, then plug the AC cord into an AC outlet.
4. Set the Power Switch to the "ON" position.
Note
For safety reasons, do not stretch, bend, or pinch the AC cord.
imc2240a.gif
5. Perform the following operation with a proprietary telephone (PT) connected to JACK 01.
a. Press the PROGRAM button.
b. Press asterisk.gif #.
c. Enter 1234.
d. Enter 999.
e. Press the NEXT (SP-PHONE) button.
f. Press the SELECT (AUTO ANS/MUTE) button until "All Para" is displayed.
g. Press the STORE (AUTO DIAL/STORE) button.
h. Press the END (HOLD) button.
i. Press the PROGRAM button.
• The PBX will be initialised with the default values. The type of outside (CO) lines is automatically detected.
• If the PBX does not function properly, refer to "4.1.5 System Reset with System Data Clear".
6. Programme the PBX using either one of the following methods:
a. PC programming. Refer to "Section 3, Section 3 Guide for KX-TE Maintenance Console".
b. PT programming. Refer to "3.3 PT Programming" of the Feature Guide. Users in countries such as Italy and the Czech Republic are required to set the country code prior to all other settings.
CAUTION
• The PBX is powered as long as the AC cord is plugged into an AC outlet, even if the Power Switch is set to the "OFF" position.
• The power supply cord is used as the main disconnect device. Ensure that the AC outlet is located/installed near the equipment and is easily accessible.
Notes
• If the outside (CO) lines you use are not connected to the PBX, outside (CO) line type cannot be automatically detected.
• Use only the AC cord included with the PBX.
• If the PBX will not be used for an extended period of time, set the Power Switch to the "OFF" position and disconnect the AC cord from the AC outlet to conserve power.