Maximum Cabling Distance

Door opener current limit: 30 V DC/125 V AC, 3 A maximum

Installing the Doorphone (KX-T30865)

1.

Loosen and remove the screw at the bottom of the case to separate the doorphone into 2 halves.

2.

Pass the wires through the hole in the base cover, and attach the base cover to a wall using 2 screws.

Note
	Two kinds of screws are included with the KX-T30865. Please choose the appropriate screws for your wall type.

:

when a doorphone plate has been fixed to the wall

:

when you wish to install the doorphone directly to the wall

3.

Connect the wires to the screws located in the front cover.

4.

Re-attach the 2 halves and re-insert and tighten the screw.

Connecting Doorphones (KX-T30865)

1.

Connect the Doorphone Card to the terminal boxes using 4-conductor wiring and modular connectors.

2.

Connect the wires of doorphones 1 and 3 to the red and green screws on the appropriate terminal box.

3.

Connect the wires of doorphones 2 and 4 to the yellow and black screws on the appropriate terminal box.

Connecting Door Openers

1.

Use a flathead screwdriver to press and hold open the button below the terminal, and insert the wire coming from the door opener into the terminal.

2.

Wrap the strap around all of the cords. (→ 2.2.4 Securing Cords)

Notes
	•	We recommend using UL1015 wire or an equivalent for wiring.
	•	The wire should be between 0.45 mm and 1.1 mm in diameter excluding the coating.